#StackBounty: #unity #c# #collision-detection #physics #collision-avoidance How do I keep a rigidbody from making unnecessary collision…

Bounty: 50

I have been having trouble with a custom character controller I am making. The root of the problem lies with collisions. I am trying to make movement code, but I have a problem with ground movement. Pay attention to this gif. It might be hard to notice due to the low frame rate, but the collider registers collisions with objects (in red) that do not point out of the ground. They share the same y-position as the ground. I’ve printed the normals of the collisions, and there are a lot of normals that are perpendicular to the normal of the ground (which is causing the rigidbody to get stuck).

The problem lies with collisions in unity. If I were to print the y-position of the bottom of my collider, it would be just a tad lower than the y-position of the ground. The collider actually rests below the ground by an almost negligible amount (which is why it doesn’t always collide with these objects).

Here is what I have tried: I created a function that runs at the beginning of every FixedUpdate() that uses current collisions to change the y-position of the rigidbody. It only runs on collisions that would ground the player (meaning that they are below the collider). The problem with this approach is that the same issue can occur with walls, meaning that the collider can get stuck on walls. I cannot create another function that would do the same for walls for various reasons.

Here is what would fix the issue: I need help figuring out how I can make collisions more discrete in unity. Colliders rest slightly below objects when ontop of them. They can also “sink” just a little into walls. In other words, colliders can rest into other colliders, and I need this to stop.

Any help is appreciated. Thank you.


Get this bounty!!!

Leave a Reply

This site uses Akismet to reduce spam. Learn how your comment data is processed.